And it&#39;s non-marring should you happen to exceed your depth stop.<div><br></div><div>;-]</div><div><br></div><div>Not that I ever have of course.............I had this friend, see..........</div><div><br></div><div>William R. Monroe</div>
<div><br></div><div><br></div><div><br><br><div class="gmail_quote">On Fri, Nov 2, 2012 at 1:23 PM, Chuck Behm <span dir="ltr">&lt;<a href="mailto:behmpiano@gmail.com" target="_blank">behmpiano@gmail.com</a>&gt;</span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">&gt;Paul<br>
<br>
Before you remove the pins, tape a hammer shank against the side of your tuning pin punch, so that the shank touches the plate.<br>
<br>
Wim&lt;<br><br>The trouble with a rigid &quot;depth gauge&quot; such as a hammer shank is that each time you tap the pin down until the shank makes contact with the plate, it will be pushed up a bit, until there is a discernible difference. <br>

<br>I&#39;ve used the same method as Bill Monroe for years, a sliver of rubber wedge that I tape (with electrical tape) to the side of the punch. Works great. Chuck Behm<br>
</blockquote></div><br><br>
</div>