This <a href="http://www.stewmac.com/tsarchive/ts0176.html?utm_source=newsletter&amp;utm_medium=email&amp;utm_campaign=ts0176">video</a> from Stewart-MacDonald demonstrates another way to size and round a dowel.  And before everyone reacts with &quot;But it&#39;s end-grain&quot; (like I did), watch it to the end... <div>
<br></div><div>Paul Bruesch</div><div>Stillwater, MN<br><br><div class="gmail_quote">On Sat, Nov 3, 2012 at 9:55 PM, Jim Ialeggio <span dir="ltr">&lt;<a href="mailto:jim@grandpianosolutions.com" target="_blank">jim@grandpianosolutions.com</a>&gt;</span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><br>
Sometimes one needs a true round dowel.   The dowels you purchase unless they are freshly milled will be out of round, sometimes significantly, because of unequal tangential &amp; radial dimensional changes. As well, some mass market dowels are run on a 4 sided molder which does not produce a round dowel right off the machine.<br>

<br>
One doesn&#39;t always needs a dead round dowel, but when you do it&#39;s not a cost thing...this is one of the only ways to get it.<span class="HOEnZb"><font color="#888888"><br></font></span></blockquote></div></div>