<font color='black' size='2' face='Arial, Helvetica, sans-serif'>
<div><font style="background-color: transparent;" face="Arial, Helvetica, sans-serif">Mark</font></div>

<div>&nbsp;</div>

<div>I just&nbsp;replaced a set of springs on a 1098. I measured wrong, and got the 2" long tails, so I had to cut each one of them and bend the tip.&nbsp;I should have gotten the spinet hammer butt springs, (Schaff 3777) which are only 1 3/8" long,&nbsp;which probably would have worked without modification. Steinway doesn't sell them any more.</div>

<div>&nbsp;</div>

<div>Wim</div>

<div></div>

<div style="clear: both;">
<div>&nbsp;</div>
</div>

<div></div>

<div></div>

<div style="color: black; font-family: arial,helvetica; font-size: 10pt;">-----Original Message-----<br>
From: Mark Purney &lt;mark.purney@mesapiano.com&gt;<br>
To: pianotech &lt;pianotech@ptg.org&gt;<br>
Sent: Thu, Dec 27, 2012 10:28 am<br>
Subject: [pianotech] Old Steinway K-52 butt springs<br>
<br>







<div style="margin: 0px; color: rgb(0, 0, 0); font-family: Tahoma, Verdana, Arial, Sans-Serif; font-size: 12px; background-color: rgb(255, 255, 255);" id="AOLMsgPart_0_ffcaee14-3a96-4e87-b059-2bba133a68b1">

<pre style="font-size: 9pt;"><tt>Just curious - for those who've had to replace the butt springs on an 
old K-52, do you make your own springs, or modify aftermarket springs 
(which are too long)? Or is there a supplier that sells shorter springs 
to fit the Steinway?

</tt></pre>
</div>
 <!-- end of AOLMsgPart_0_ffcaee14-3a96-4e87-b059-2bba133a68b1 -->



</div>
</font>