<font color='navy' size='2' face='Comic Sans MS, sans-serif'><font color="#000080" face="Comic Sans MS, sans-serif" size="2">My bet is the block to plate flange fit was not&nbsp;</font><font color="#000080" face="Comic Sans MS, sans-serif">solid and kept shifting.</font><font color="#000080" face="Comic Sans MS, sans-serif" size="2">&nbsp; Been there done that.&nbsp;</font>
<div><font color="#000080" face="Comic Sans MS, sans-serif" size="2">&nbsp;In my case I ixed the issue with hard wood shims wedged up between the plate flange and the block.&nbsp;</font></div>

<div><font color="#000080" face="Comic Sans MS, sans-serif" size="2">The piano was an early (ancient) 60s Yamaha</font>
<div style="color: navy; font-family: 'Comic Sans MS', sans-serif; font-size: 10pt;">Dake<br>
<br>

<div style="clear:both"><font size="1" color="royalblue"><b><font face="Georgia, Times New Roman, Times, Serif"><font color="black"><font color="mediumblue" face="Comic Sans MS, sans-serif">Dale Erwin R.P.T.<br>
<font color="green">Erwin's Piano Restoration Inc.</font><br>
</font></font></font></b></font><font color="darkgreen"><span style="font-style: italic;"><b><font size="1"><font size="1" color="black"><font color="blueviolet"><font color="black"> <font color="black" face="Comic Sans MS, sans-serif">Mason &amp; Hamlin</font><font face="Comic Sans MS, sans-serif">/Steinway/</font><font color="black" face="Comic Sans MS, sans-serif">U.S. pianos</font><font face="Comic Sans MS, sans-serif"><br>
</font></font></font></font><font size="1" color="cornflowerblue" face="Comic Sans MS, sans-serif">www.Erwinspiano.com</font><font size="1"><br>
</font><font size="1" color="crimson" face="Comic Sans MS, sans-serif">Phone: 209-577-8397</font><br>
<font color="darkgreen"></font></font></b></span></font><tt><tt><font color="darkgreen"><br>
&nbsp;</font><br>
&nbsp; <font size="2"></font></tt></tt><br>
<br>
</div>
<br>
<br>

<div style="font-family:arial,helvetica;font-size:10pt;color:black">-----Original Message-----<br>
From: Jon Page &lt;jonpage@comcast.net&gt;<br>
To: pianotech &lt;pianotech@ptg.org&gt;<br>
Sent: Fri, Jan 11, 2013 8:53 pm<br>
Subject: Re: [pianotech] frustrated<br>
<br>







<div id="AOLMsgPart_0_cf212d60-ecc4-4a01-b7c8-a4a34386e281" style="margin: 0px;font-family: Tahoma, Verdana, Arial, Sans-Serif;font-size: 12px;color: #000;background-color: #fff;">

<pre style="font-size: 9pt;"><tt>I tuned a small Kawai grand which was donated to a school. It took about 
four hours to get it where I could walk away. When I pulled up the 
treble (not too much), it went way sharp afterwards. I went over it 
again to lower the pitch and it went way flat. Pulled up...crept sharp 
but not as much. After the third or fourth pass thru the treble, the 
piano was good enough. I charged for the time. Never heard back from 
them...problem solved.

Maybe that's why it was donated.

-- 
Regards,

Jon Page

</tt></pre>
</div>
 <!-- end of AOLMsgPart_0_cf212d60-ecc4-4a01-b7c8-a4a34386e281 -->



</div>
</div>
</div>
</font>