<div dir="ltr">I searched my not inconsiderable archives for an answer, but have come up empty-handed. I am using 1/0 Denro blued tuning pins in a new multi-lam Maple pinblock, and need to order the drill bit. I&#39;d like to double-drill - makes sense. The Pianotek catalog recommends, in effect, a drill bit .016&quot; to .021&quot; under the diameter of a 2/0 pin in a multi-lam pinblock. Following that logic, I could use the .250&quot; on the first pass, and the .261&quot; (.015&quot; under) or .257&quot; (.019&quot; under) drill bit on the second pass. Also, I like the idea of the brad-points, but also like the idea of the other ones, which are &quot;slow spiral.&quot;  Any recommendations?<br>
</div>