<font color='black' size='2' face='Georgia, Times New Roman, Times, Serif'><font size="2" style="color: black; font-family: Georgia, 'Times New Roman', Times, serif; ">Hmm, Ok, I have been using homemade chasers instead of reamers, who knew? &nbsp;</font>
<div style="color: black; font-family: Georgia, 'Times New Roman', Times, serif; "><font size="2">&nbsp; &nbsp;</font></div>

<div><font size="2"><font face="Georgia, Times New Roman, Times, serif">&nbsp; &nbsp;The &nbsp;K bit that I use to chase a Steinway 2/0 block prior to repinning with 3/0 pins manages to cut something out of those holes with the cutting edges I left in the middle of the bit. &nbsp;Especially down at the bottom, where there is often uncompacted&nbsp;pin block holes drilled for the 2/0 pins.&nbsp;</font></font></div>

<div><font size="2"><font face="Georgia, Times New Roman, Times, serif">&nbsp; &nbsp; &nbsp;I don't know what is being sheared off the inside of the holes, but there is wood removed when I do this, even though the bit is supposedly smaller than the hole should be. &nbsp;</font></font></div>

<div><font size="2"><font face="Georgia, Times New Roman, Times, serif">Regards,&nbsp;<br>
</font></font><br>

<div style="color: black; font-family: Georgia, 'Times New Roman', Times, serif; font-size: 13px; clear: both; "><font color="black" face="arial" size="2">Ed Foote RPT<br>
http://www.piano-tuners.org/edfoote/well_tempered_piano.html</font></div>
<br>
<br>

<div style="color: black; font-family: helvetica, arial; font-size: 10pt; ">-----Original Message-----<br>
From: Jim Ialeggio&nbsp;
<div id="AOLMsgPart_0_8b6ca41d-a6bd-4e9c-8b6f-5c7a4c793370" style="margin: 0px;font-family: Tahoma, Verdana, Arial, Sans-Serif;font-size: 12px;color: #000;background-color: #fff;"><pre style="font-size: 9pt;"><tt>&lt;I have made my own pinblock reamers from bits in which I grind away all 
the cutting edges for the first inch or so of the bit. It makes for an 
accurate pilot without chewing a
sideways hole on the way in.

This is interesting and makes a lot of sense.

So, what exactly is the cutting action of a reamer?  Is is simply a 
scraping action?  If so, what keeps the 1st hole's wall fibres from just 
bending over rather than actually being sheared off ?

 </tt></pre>
</div>
 <!-- end of AOLMsgPart_0_8b6ca41d-a6bd-4e9c-8b6f-5c7a4c793370 -->



</div>
</div>
</font>