<HTML><FONT FACE=arial,helvetica><FONT SIZE=2>In a message dated 1/12/01 10:57:36 PM Central Standard Time,
<BR>btrout@desupernet.net (Brian Trout) writes:
<BR>
<BR>
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Any little secrets anyone has up their sleeve? </BLOCKQUOTE>
<BR>
<BR>I had two suggestions but I'm afraid Conrad beat me to both. I narrowed the
<BR>shank on my tool so that it is very thin to be able to fit in between the
<BR>dowel type let off buttons that many actions have.
<BR>
<BR>Secondly, just as with the hammer line suggestion I had, depress the key or
<BR>as Conrad said, tilt the jack so that the screw you need to reach becomes
<BR>more easily accessible. Even though you need to see it at rest to see if it
<BR>is regulated properly, you can turn the screw in any other point of travel,
<BR>then check it when it returns. The difference between being exactly right
<BR>and a little off is always just a tweak away, one way or the other.
<BR>
<BR>Bill Bremmer RPT
<BR>Madison, Wisconsin</FONT></HTML>