<HTML><FONT FACE=arial,helvetica><FONT SIZE=2>In a message dated 6/10/0=
3 7:22:40 AM Pacific Daylight Time, Richard.Brekne@grieg.uib.no writes:
<BR>
<BR>
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-=
LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">If you can get a tool in th=
ere at all, then you can push the whole spring downwards till you loosing th=
e coil a bit... no ?
<BR></FONT><FONT COLOR="#000000" SIZE=3 FAMILY="SANSSERIF" FACE="Ar=
ial" LANG="0"></BLOCKQUOTE>
<BR></FONT><FONT COLOR="#000000" SIZE=2 FAMILY="SANSSERIF" FACE="Ar=
ial" LANG="0">
<BR>Ric,
<BR>
<BR>Since the spring is bowed upward against the bottom of the balancier, th=
e only portion of spring that is visible is a tiny length near the rep lever=
/flange center. I could barely get my spring tool in there to pull it out of=
the slot, and there's nothing to rub, because the length of the spring is p=
ressing upward against the lever. It's backwards, if you ask me.  =
;
<BR>
<BR>This falls into "I've never seen this before"...(A very large file....:-=
)
<BR>
<BR>Dave Stahl</FONT></HTML>