<html> Hi Wally,                I can snail mail, but alas no scanner, but Steve Brady has some photos of the jig in action on a table saw.  I think he has scanning capabilities. Roger. At 12:13 AM 16/04/00 -0400, you wrote: <blockquote type=cite cite>Roger:  could you e-mail me a picture?  I could use it Mon. on an out of town job. Wally Wilson Roger Jolly wrote: <blockquote type=cite cite> At 10:06 PM 14/04/00 -0400, you wrote: <blockquote type=cite cite>Thanks for the replys everyone.  Newton and Jon honed in on the info I was seeking.  My post was perhaps a little vague but I was looking for info on the side cut (tapering) not the tail arcing, but that was interesting reading too.</blockquote> Hi Doug,                  I've still got a few drawings of the tapering jigs that I used in the KC class,  Bill Spurlock's new jig is a modified copy, but can't  taper hammers on the shank. Also better material removal happens when the cut starts from the tail, If you give me a mailing address I'll send a copy. Roger Roger JollySaskatoon, Canada.306-665-0213Fax 652-0505</blockquote></blockquote> <div>Roger Jolly</div> <div>Saskatoon, Canada.</div> <div>306-665-0213</div> Fax 652-0505 </html>