<html>
<body>
<br>
Listers and Listees,<br>
<x-tab>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;</x-tab>Thank you
for the feedback. While it is not as much discussion as I had hoped it, I
believe, had the desired result. While Ruth Phillips mentions below that
the 25Watt Rod was discontinued as a system staple I have to disagree.
The part number G6PS (top item on page 22 of the Jansen catalogue
includes both a 2' and a 4' 25 watt rod. I also disagree with others that
posted (Don I think it was) who said that the two rods producing very
different amounts of heat would not necessarily produce an imbalance. I
paraphrased to clarify my point but I can't see how it could be anything
but. Don's argument was that I did not take into account convection
currents. It would seem to me that if one was too hot to hold and the
other could be held all day being only luke warm then any convection
currents would be more in the category of WIND to not produce an
imbalance. I can agree with others who have posted that they never
noticed any problems. Neither have I. Even though the two bars produce an
entirely different amount of heat they are not necessarily doing damage.
It seems that it could certainly be said, however, that they are not
doing the best job possible. Any further thoughts?<br><br>
Greg<br><br>
<br>
At 06:25 PM 2/11/2004, you wrote:<br><br>
<blockquote type=cite class=cite cite><font face="Times New Roman, Tim=
es">Greg
- the 25 watt rod was discontinued as a system staple long ago.&nbsp;
<br>
On the soundboard, once compression has taken place, drying the wood is
not going to make it disappear.&nbsp; When you install a system you will
find that the wood changes - that is about all you can say with
certainty.&nbsp; With the right equipment, properly installed, the system
will stabilize the wood.&nbsp; Once it stabilizes, you can make
corrections based on what you find at that point.&nbsp; It may take some
time as there will be residual change, such as there is when you change
pitch.&nbsp; Every change causes reactions, and you keep at it until the
change is so miniscule that the reaction is meaningless.<br>
I hope this helps to clarify what you found.<br>
Ruth Phillips<br>
</font>&nbsp;<br>
</blockquote>
<x-sigsep><p></x-sigsep>
Greg Newell<br>
Greg's piano Forté<br>
<a href="mailto:gnewell@ameritech.net"=
 eudora="autourl">mailto:gnewell@ameritech.net</a></body>
</html>