<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <META content="MSHTML 6.00.2900.2722" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><STRONG><FONT face=Arial>What is the best way to repin a grand with Accujust pins? The tuning pins are looser, than they should be.   They don't like my suggestion of trying C/A glue.</FONT></STRONG></DIV> <DIV><STRONG><FONT face=Arial></FONT></STRONG> </DIV> <DIV><STRONG><FONT face=Arial>Do we repin, and readjust the bearing from scratch?  How would that be done.</FONT></STRONG></DIV> <DIV> </DIV> <DIV> <STRONG><FONT face=Arial>Do we maintain the height, by clamping at the accujust pin, to hold position when the tension is off?</FONT></STRONG></DIV> <DIV><STRONG><FONT face=Arial></FONT></STRONG> </DIV> <DIV><STRONG><FONT face=Arial>What is the best thing to use as a clamp, if above is true? Is a spring clamp with cushioned ends, sufficient.?</FONT></STRONG></DIV> <DIV><STRONG><FONT face=Arial></FONT></STRONG> </DIV> <DIV><STRONG><FONT face=Arial>Or do we just make a few small blocks, and test fit each one first?</FONT></STRONG></DIV> <DIV><STRONG><FONT face=Arial></FONT></STRONG> </DIV> <DIV><STRONG><FONT face=Arial>Any suggestions to make this job easier, are welcome.</FONT></STRONG></DIV> <DIV><STRONG><FONT face=Arial></FONT></STRONG> </DIV> <DIV><STRONG><FONT face=Arial>Best regards,</FONT></STRONG></DIV> <DIV> </DIV> <DIV><STRONG><FONT face=Arial>John M. Ross<BR>Windsor, Nova Scotia, Canada<BR><A href="mailto:jrpiano@win.eastlink.ca">jrpiano@win.eastlink.ca</A></FONT></STRONG></DIV></BODY></HTML>