<HTML><FONT FACE=arial,helvetica><FONT SIZE=2>In a message dated 6/8/02 12:02:41 AM !!!First Boot!!!, ptuner@optonline.net writes:
<BR>
<BR>
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">I will be reassembling a damper system in an old S&S grand. It is one of
<BR>those systems that was born without regulating screws on each underlever
<BR>for adjustment to the lift tray. Is there any efficient way to adjust them
<BR>so that they all lift in unison with the pedal? I'm aware of the old
<BR>method using center rail punchings, or something similar, as shims, but
<BR>there must be a better way. Any advice would be appreciated.
<BR>
<BR>Thanks,
<BR>
<BR>-Matt Wynne
<BR></BLOCKQUOTE></FONT><FONT COLOR="#000000" SIZE=3 FAMILY="SANSSERIF" FACE="Arial" LANG="0">
<BR>Even new S&S don't have a regulating screw to adjust the damper flanges with the tray. The only way to adjust them is with paper shims, which go under the felt.
<BR>
<BR>Wim
<BR></FONT></HTML>