<!doctype html public "-//w3c//dtd html 4.0 transitional//en"> <html> Ron, <p>I marred one out of the set, still which upset me a little 'coz these bebbes are getting recycled soon. I thought about a hard brass crowbar/rocker with a 0.147" slot cut at a slight angle so when the flat bottom of the fulcrum sets down, a little pressure is applied to the pin. At least it'd make fewer marks than visegrips. And I always seem to hurt my fingers. <p>Clark <br>  <blockquote TYPE=CITE> <pre>Slide hammer on a pair of vise grips. If you don't whack your finger with the weight, it should be relatively painless, and a lot faster. Ron N</pre> </blockquote> </html>