<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=US-ASCII"> <META content="MSHTML 6.00.2800.1400" name=GENERATOR></HEAD> <BODY id=role_body style="FONT-SIZE: 10pt; COLOR: #000000; FONT-FAMILY: = Arial" bottomMargin=7 leftMargin=7 topMargin=7 rightMargin=7><FONT id=rol= e_document face=Arial color=#000000 size=2> <DIV> <DIV><FONT size=3><STRONG><U>   Terry</U></STRONG></FONT></DIV> <DIV><STRONG><U><FONT size=3>       Love to = see it.</FONT></U></STRONG></DIV> <DIV><STRONG><U><FONT size=3>   Dale</FONT></U></STRONG></DIV> <DIV><STRONG><U><FONT size=3>  </FONT></U></STRONG></DIV> <BLOCKQUOTE style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: blue 2px solid"><= FONT style="BACKGROUND-COLOR: transparent" face=Arial color=#000000 size= =2><FONT size=3><STRONG><U>[caught in the filters]</U></STRONG></FONT><BR><BR>Beg= in forwarded message:<BR><BR>From: "Farrell" <mfarrel2@tampabay.rr.com><BR>Date: October 13, 2004 6:21:04 PM CDT<BR>To: "Pianotech" <pianotech@ptg.org><BR>Subject: Re: Epoxy/bri= dge pins application<BR><BR><BR>Notch first. If I'm using the original size pi= ns, I put a drop (or <BR>whatever I need) of epoxy in hole, dab tip of pin and= insert into hole. <BR>If I'm doing a new bridge (yup, I epoxy those also),= I drill the <BR>standard slightly smaller hole, put a drop of epoxy in hole,= dab new <BR>pin in epoxy and tap into place. I typically have a small col= lar of <BR>epoxy form at the base of the bridge pin. I take a cheap little art= ist <BR>brush with a little acetone on it and spread the excess epoxy over the= <BR>notch area. I take a paper towel with a little acetone on it and clean= <BR>off the top of the bridge. It ends up looking like this:</FONT></BLOCKQUOTE></DIV> <DIV></DIV> <DIV> </DIV></FONT></BODY></HTML>