<html>
<font face="arial">When re stringing these pianos, we re scale the bass
so the bi chords have the same speaking length. A huge improvement
in tone and tunability.<br>
Run a drill through the cast agraffes to clean and polish them, you will
find that string rendering will improve, and there will be less capo
noise. Heintmans are notorious for string rendering problems in the
treble.<br>
The screws we treat in much the same manner, as below.<br>
Roger<br><br>
<br><br>
</font><blockquote type=cite class=cite cite><font face="arial" size=2>I
clean the screws with a wire wheel on a grinder. I put them in a box with
chicken wire. (the very small squares, which are about 1/2"
square),. I spray them with the same gold paint as the plate. Unless they
are nickel plated to begin with. You should polish those up, and spray
them with a clear coat of lacquer. <br><br>
I leave the hitch pins in, and spay them. That is not a problem. You can
spray the agraffes, too, but for a super look, take them out and polish
then, since they are brass. Keep should them in order when you take them
out, and put them back in the same hole. <br>
Wim </blockquote>
<x-sigsep><p></x-sigsep>
Roger</font></html>