<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; =
charset=iso-8859-1">
<META content="MSHTML 6.00.2800.1458" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT face=Arial size=2>Robin Hufford said: "<FONT =
face="Times New Roman"
size=3> would be to<BR>pull the bridge pins and seat them in either =
epoxy or
CA. One should try to<BR>allow the material to flow out into the
cracks."</FONT></FONT></DIV>
<DIV>NOT what I would recommend! Pulling the bridge pins is unnecessary, =
usually
causes damage to the bridge cap and is time consumingly unnecessary. =
Refer to my
epoxying technique of a few days ago, using a soldering iron and epoxy! =
Sheesh!
It's my opinion, that the only time to pull bridge pins, is when =
you are
going to recap. And, while I'm on the subject....If the =
Bass Bridge
needs capping...So Does the Treble!!!!!</DIV>
<DIV>Regards, </DIV>
<DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool
Police<BR>Squares R I</FONT></DIV></BODY></HTML>