<!doctype html public "-//w3c//dtd html 4.0 transitional//en">
<html>
Last one. This is the receiver board removed and modified.
I have removed the original wiring and speaker and solder on new connections.
The red and white go to the battery. The Black and green by-pass
directly from the RF circuit and go to the SAT. There are two additional
wires not included here that go to the LED light which comes on to verify
that the unit is receiving the signal.
<br>
<p><img SRC="cid:part1.3988F419.59A073DF@nevada.edu" height=229 width=239></html>