<!doctype html public "-//w3c//dtd html 4.0 transitional//en">
<html>
Roger: could you e-mail me a picture? I could use it Mon. on
an out of town job.
<p>Wally Wilson
<p>Roger Jolly wrote:
<blockquote TYPE=CITE> At 10:06 PM 14/04/00 -0400, you wrote:
<blockquote type=cite cite><font size=-1>Thanks for the replys everyone.
Newton and Jon honed in on the info I was seeking. My post was perhaps
a little vague but I was looking for info on the side cut (tapering) not
the tail arcing, but that was interesting reading too.</font></blockquote>
<p><br><font size=-1>Hi Doug,</font>
<br><font size=-1>
I've still got a few drawings of the tapering jigs that I used in the KC
class, Bill Spurlock's new jig is a modified copy, but can't
taper hammers on the shank.</font>
<br><font size=-1>Also better material removal happens when the cut starts
from the tail,</font>
<br><font size=-1>If you give me a mailing address I'll send a copy.</font>
<br><font size=-1>Roger</font>
<br> Roger JollySaskatoon, Canada.306-665-0213Fax 652-0505</blockquote>
</html>