<HTML>In a message dated 10/14/02 9:15:26 AM Central Daylight Time, gholley@hi-techhousing.com writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">List.  I need information on securing a new hammer spring rail for a Baldwin-Howard, Spinet, drop action, with stickers.  Some springs are broken, others are all bent, in general hammers won't return</BLOCKQUOTE> Instead of replacing the whole rail, why don't you replace the springs? You can buy new springs from Schaff, (part No. 3777). They are not difficult to remove, but it will be tricky to put them back in the hole. If they are too long, cut off the end, and then put a little bend in the wire to fit in the hammer butt. Good luck Wim </HTML>