<html>
Hi, Dale <br>
<br>
What do you think of slacking off a warbler treble string, pulling out
the pin if it's willing to come, and putting the CA into the hole --
versus just putting a drop at the bass of the pin without changing the
wire? Any benefits to getting more CA into the bridge? Worth the time and
tuning stability expended?<br>
<br>
I did this once on a few notes of (an unnamed but fairly new) grand with
tuning stability issues, and found that when I put CA glue down one hole
and put the bridge pin back in, CA spurted out of a neighboring hole.
Obviously, there can be cracks down there ... <br>
<br>
Susan <br>
<br>
At 01:22 AM 8/5/2005 -0400, you wrote:<br>
<blockquote type=cite class=cite cite><font face="arial" size=2> </font><font face="arial">
</font><font face="arial" size=2><br>
</font><font face="arial"> Susan </font><font face="arial" size=2><br>
</font><font face="arial"> yes & Perhaps wee bit more craftsmanship at the factory. The list of complaints seems to be getting longer</font><font face="arial" size=2><br>
</font><font face="arial"> Dale</font><font face="arial" size=2></font>
<dl>
<dd>At 01:07 PM 8/4/2005 -0500, Andrew wrote:
<dd>>A number of single strings in the high treble were warbling. Tried gentle
<dd>>seating of strings and pins to very little effect.<br>
<br>
<br>
<br>
<dd>Possibly putting a drop of CA glue at the base of the front bridge pins?
<dd>For warblers, that is.<br>
<br>
</dl> </blockquote></html>