<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1400" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>List.  In regulating a grand with = all new wippens, hammers and shanks, I'm having a problem with = determining</FONT></DIV> <DIV><FONT face=Arial size=2>the correct dimension between the top = of the jack and the top of the repetition lever, in setting the repetition lever height.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>On the back page of the March 2004 = Journal, the Yamaha, Little Red Schoolhouse, Step 18 of regulation, says that there = should be</FONT></DIV> <DIV><FONT face=Arial size=2>0.2 mm between the top of the jack and = the top of the repetition lever.  And yes, I've read all of the other info = provided, but I'm surely not</FONT></DIV> <DIV><FONT face=Arial size=2>that great at a tactile sensation with = a finger to determine 0.2 mm.  </FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>And I don't know how to measure the = 0.2mm with a gauge in the lever window.  I read some place that this thickness = is about the same</FONT></DIV> <DIV><FONT face=Arial size=2>as a business card, but that doesn't help.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Does anyone have a better, step-by-step = procedure to follow to set the lever height?</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Many thanks in advance</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Gordon Holley</FONT></DIV> <DIV><FONT face=Arial size=2>Associate Member</FONT></DIV> <DIV><FONT face=Arial size=2>Chapter 467, Indiana</FONT></DIV> <DIV><FONT face=Arial size=2>Goshen, IN</FONT></DIV></BODY></HTML>