<html>
<font size=3>At $43/quart it is a very good idea to salvage the residue.
What would you<br>
dissolve it in? New Protek? Incorporate the 'cake' into your
own version<br>
of VJ Lube?<br>
<br>
You could always transfer a new can to a more air tight container but
the<br>
last time I ordered, it arrived in a plastic container which is
tight.<br>
<br>
Regards,<br>
<br>
Jon Page<br>
<br>
At 03:19 AM 09/20/2000 -0400, you wrote:<br>
<blockquote type=cite cite>I have had several tins of Protek totally
evaporate, in my shop, but it is <br>
Arizona and my shop sometimes gets to 90 to 100 degrees. <br>
<br>
I checked the cans, and each would not seal well. That is, put the cap on
<br>
tightly, then squeeze, and listen to the air going in and out. Try it.
They <br>
are lousy containers. <br>
<br>
More to the point, the material should be able to be resuspended in some
<br>
solvent. I have saved the cans with the material caked at the bottom.
Have <br>
not had time to try experimentation yet, but has anyone else tried and
found <br>
a good solvent to reconstitute the materials?<br>
<br>
Bill Simon<br>
Phoenix </font></blockquote></html>