<!doctype html public "-//w3c//dtd html 4.0 transitional//en">
<html>
I have a question for you folks who are well aquainted with different properties
of wood... what mixes and what doesnt.
<p>If one was to cut out a section of the key to put in an assembly like
my keymagnet assembly, what king of wood type would be a good choice
to use for the assembly. It needs to be hard enough to facilitate a center
pin that holds the magnet shank.
<p><img SRC="cid:part1.3F0F2FEA.9219E115@grieg.uib.no" height=204 width=350>
<br>Thanks
<p>RicB
<p>--
<br>Richard Brekne
<br>RPT, N.P.T.F.
<br>UiB, Bergen, Norway
<br><A HREF="mailto:rbrekne@broadpark.no">mailto:rbrekne@broadpark.no</A>
<br><A HREF="http://home.broadpark.no/~rbrekne/ricmain.html">http://home.broadpark.no/~rbrekne/ricmain.html</A>
<br><A HREF="http://www.hf.uib.no/grieg/personer/cv_RB.html">http://www.hf.uib.no/grieg/personer/cv_RB.html</A>
<br> </html>