<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1458" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Paul C said: "<FONT face="Times New = Roman" size=3> Clean up is easy with a sharp chisal when the epoxy reaches a = stiff<BR>gum state; acetone to follow...."</FONT></FONT></DIV> <DIV>Paul,</DIV> <DIV>Yikes! Refer to my statement about DAG. The same applies to = Acetone, only more so!!! If you use ANY substance known to thin/remove epoxy, for = clean up, you will DEGRADE the Epoxy!!!! I keep seeing this and am amazed that = there are not more failures! Epoxy is very sensitive to this sort of thing. Don't = do it!</DIV> <DIV>As for the clean up w/a sharp chisel, I'd say that's o.k., but not necessary with my system! Dental tools and a specially shaped knife is = all that is needed to ensure a "pure" termination. Chisels are a bit over-kill = IMO. Besides, I wouldn't subject my Good Chisels to banging up against bridge = pins. Hmmm? Not even my Bad Chisels!<G></DIV> <DIV>Best Regards,</DIV> <DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool Police<BR>Squares R I</FONT></DIV></BODY></HTML>