<DIV>When I did my keytops, the old tops were about .040 on the micrometer. The new tops I installed, were .080. I was using a router to rout off the difference. What ways to you all use? Is there some sort of conversion table to use for measurements?</DIV>
<DIV> </DIV>
<DIV> </DIV>
<DIV>Matthew</DIV><p>
                <hr size=1> <a href="http://us.rd.yahoo.com/evt=34442/*http://www.yahoo.com/r/hs">Start your day with Yahoo! - make it your home page </a>