<HTML><FONT FACE=arial,helvetica><FONT SIZE=2>In a message dated 01/27/2001 11:34:46 AM Central Standard Time,
<BR>ilvey@jps.net writes:
<BR>
<BR>
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Oh, I get it...you slide in the device until it touches the leveling
<BR>sticking...Very clever!
<BR>
<BR>David I.
<BR>
<BR>On 27 Jan 2001, at 10:20, Kdivad@AOL.COM wrote:
<BR>
<BR></BLOCKQUOTE>
<BR>
<BR>Exactly, you slide the guage in between the key and the straight edge until
<BR>the double thickness of, for example, the .010 just slides freely but the
<BR>combination of the .010 and .015 will not go without dragging.
<BR>
<BR> I have also found it quicker to force 3 or 4 balance rail paper punchings
<BR>(.060) on the front rail key pins for the end keys and raise or lower them
<BR>until you get the correct key height for leveling. The force fit provides
<BR>more than enough friction to support your straight edge (if you are not too
<BR>aggressive setting it down) and it is so quick this way as to be almost scary.
<BR>
<BR>David Koelzer
<BR>Associate
<BR>DFW</FONT></HTML>