<html>
<body>
<font size=3>At 10:37 AM 1/29/04, you wrote:<br>
<blockquote type=cite class=cite cite>I noticed the problem 
appeared<br>
once again when the soap lady took over the CEO position of&nbsp;
Baldwin.&nbsp; She,<br>
of course is the one who lost her job when she ran the company into
the<br>
ground enough for Gibson to be required to buy Baldwin just to keep it
in<br>
business.&nbsp; I hope they have raised the standards back to what they
should<br>
be, now.</font></blockquote><br>
Sorry to be such a pessimist, but why would you ever think that!
They<br>
make guitars, after all! :-) <br><br>
Avery <br><br>
<blockquote type=cite class=cite cite><font size=3>D.L. Bullock&nbsp; St.
Louis<br>
<a href="http://www.thepianoworld.com/" eudora="autourl">www.thepianoworld.com</a>
&lt;<a href="http://www.thepianoworld.com/" eudora="autourl">http://www.thepianoworld.com</a>&gt;<br><br>
<br><br>
-----Original Message-----<br>
From: Dave Nereson [<a href="mailto:davner@kaosol.net" eudora="autourl">mailto:davner@kaosol.net</a>]<br>
Sent: Thursday, January 29, 2004 2:47 AM<br>
To: Pianotech<br>
Subject: Re: baldwin buzz<br><br>
<br><br>
----- Original Message -----<br>
From: &lt;richard.ucci@att.net&gt;<br>
To: &lt;pianotech@ptg.org&gt;<br>
Sent: Tuesday, January 27, 2004 6:09 PM<br>
Subject: baldwin buzz<br>
&gt; Hi People,<br>
&gt; Tuned a Baldwin spinet ca. 70's today. Nasty buzzzz and rattle at e,f and<br>
f#<br>
&gt; 3. Checked soundboard -no cracks; tightened soundboard buttons in back;<br>
&gt; nothing interfering with strings; bridge pins tight and not out of place;<br>
&gt; ribs good; nothing stuck in back by soundboard; pushing on bridge and<br>
&gt; soundboard didn't do anything.<br>
&gt; I could use some help on this one.<br>
&gt; Thanks,<br>
&gt; Rick Ucci/Ucci Piano<br><br>
&nbsp;&nbsp;&nbsp; There are just so many things it could be.&nbsp; Check the recent archives<br>
(earlier this week and perhaps last) under &quot;Rubber band sound&quot;.&nbsp;&nbsp; Loose<br>
hardware is notorious, fallboard hardware, hinges, hinge pins, etc.,<br>
casters, loose legs, music rack, loose action bolt nuts, loose anything --<br>
peeling veneer, dried glue squeeze-out, loose bridge pins, strings<br>
contacting edge of notching on the bridge, bottom panel clip, pedal rod pins<br>
buzzing in damper lifter rod hole (no bushings), ad infinitum -- ya just<br>
gotta be a detective and check even the unlikely things.&nbsp; --David Nereson,<br>
RPT<br><br>
<br><br>
<br>
_______________________________________________<br>
pianotech list info: <a href="https://www.moypiano.com/resources/#archives" eudora="autourl">https://www.moypiano.com/resources/#archives</a></font></blockquote></body>
</html>