<HTML> <HEAD> <TITLE>Re: Petrof keyslip</TITLE> </HEAD> <BODY> Jerry, I just did this less than a week ago.  It worked beautifully without a= ffecting anything else. 1.  Remove case parts. 2.  Remove keys 3.  Loosen keyframe screws (8) 4.  Place shims (I used business card slivers) between keyframe and ke= yslip. 5.  With the shims in place, tighten keyframe screws. 6.  Replace keys and case parts. Time required:  20 to 30 minutes. Cliff Lesher, RPT Winfield, PA <BLOCKQUOTE> From: Jerry Cohen <emailforjc@yahoo.com> Reply-To: Pianotech <pianotech@ptg.org> Date: Wed, 16 Jun 2004 08:43:46 -0400 To: "'Pianotech'" <pianotech@ptg.org> Subject: RE: Petrof keyslip </BLOCKQUOTE> <BLOCKQUOTE>If the keyslip doesnšt come o= ff, does anyone have an efficient solution when the key fronts are rubbing a= gainst the keyslip? Thanks, Jerry Cohen NJ Chapter <BLOCKQUOTE>----- Original = Message ----- From: david heidel <mailto:dbheidel@comcast.net> To: Pianotech <mailto:pianotech@ptg.org>   Sent: Tuesday, June 15, 2004 10:47 PM Subject: Re: Petrof keyslip= I have a Petrof vertical, and have= the same problem.  I contacted the Petrof rep. and was informed that i= ndeed, it does not come off.  Don't you just love challenges like this?= David Heidel <BLOCKQUOTE>----- Original Message ----- = From: Topperpiano@aol.com To: pianotech@ptg.org Sent: Tuesday, June 15, 2004 6:43 PM Subject: Re: Petrof keyslip= Some of them do not come off. &nbs= p;A couple of the Chinese pianos have the same arrangement.  Makes for = interesting adjustments when the keys hit the keyslip. Now there's a use for the 9 pound sledge. TP </BLOCKQUOTE></BLOCKQUOTE> </BLOCKQUOTE> </BODY> </HTML>