<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1141" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial>JB Weld (Wal-mart has it). There is a rapid = cure version and a slow cure version (haven't tried the slow cure). It's easy = to work with and provides some fill, although it will run and is best in = horizontal applications. I use it all the time, at home. </FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>It is dark charcoal grey so can't be used where = visible but I've found it great for these applications:</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>1) Installing new fallboard buttons (drawer = pulls) when the screw is destroyed, the hole is huge, etc. (Hamilton studios seem = prone to this damage).</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>2) Split hammer tails on old grands and beefing = up the joint if the hammer is floppy on the shank. (Not for real nice pianos or = where hammer replacement is a possibility.)</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>3) Installing new caster sockets when the wood = is all split or worn.</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>Anybody got further = suggestions/experience?</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV> <DIV><FONT face=Arial>Alan Barnard</FONT></DIV> <DIV><FONT face=Arial>Salem, MO</FONT></DIV> <DIV><FONT face=Arial></FONT> </DIV></BODY></HTML>