<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1400" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Paul C asked: "<FONT face="Times New = Roman" size=3>List members and pin block installers:<BR><BR>What drill size = do you like for a 2/0 pin when using Delignet for the block?"<BR><BR>Paul C,</FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3>I've used Delignet for most of my career. I usually use a 6.8mm drill bit. = However, there are varying grades of Delignet and sometimes an "H" drill or a 6.9mm. I = always do several test drill holes in the scrap. I should also say, I always = use pin driving fluid, so that will make a difference in the size hole to be = drilled. (Pin driving fluid makes a tight hole somewhat = looser.)</FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3>If you do not have my Stats Chart, let me know and I'll send you = one.</FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3>Best Regards,</FONT></DIV></FONT> <DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool Police<BR>Squares R I</FONT></DIV></BODY></HTML>