<HTML style="FONT-SIZE: x-small; FONT-FAMILY: MS Sans Serif"><HEAD> <META http-equiv=Content-Type content="text/html; charset=windows-1251"> <META content="MSHTML 6.00.2800.1522" name=GENERATOR></HEAD> <BODY> <P> <DIV>Installment #2.<G> I'm sending each, separately, so's not to go over the size limits.<G></DIV> <DIV>This tool is made from a piece of Brass Bar Stock, 1/4"x3/8". The bend is done "cold". (Put it in a vise and hit it with a dead blow hammer.) The grooves are simply cut with a regular hacksaw, which should give you a groove that will accomodate most string sizes.  Cut the grooves about 1/16" deep. Grind to get the clearance to access the middle string(s).</DIV> <DIV>The way this tool works, is to simply put it on the string and push/pull with very little effort. Go easy, as this tool will give you "massive" results!!! I usually use this tool, over all others, as it is so effortless and controllable. Pull to raise the string. Push to lower. I usually place the tool about  1/2" from the agraffe to get the desired results. Have fun.<G></DIV> <DIV>Installment #3 is next. (a side view of this tool).</DIV> <DIV>Regards,</DIV> <DIV> </DIV> <DIV> </DIV> <DIV>Joe Garrett, R.P.T. (Oregon)</DIV> <DIV>Captain, Tool Police</DIV> <DIV>Squares R I</DIV> <DIV> </DIV> <DIV> </DIV> <P></P></BODY></HTML>