<HTML>In a message dated 03/12/2003 7:59:19 AM Eastern Stand= ard Time, Hazen Bannister writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT= : 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px"> <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT= : 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">need more clarification on "pit= ch raise" .... bear with me... when I do a pitch raise, I use the Sat II and re-set the tuner every octave or so so that it (hopefully) comes out close on the other end :-)</BLOCKQUOT= E> Hi, I have been using a accutuner ll for years,and have pitch raised hundreds of= pianos,and never have had to re-set the accutuner.I turn the machine on and= A4 comes up,I check the pitch on the A2 octave againt the machine,and do th= e correct overpull (about a 1/4).If the treble starts spinning the lights a = lot faster to the flat side,than the bass did,I start compensating by pullin= g by the same speed difference to the sharp side,not to much on the mid treb= le(C4 octave),but especially on up through the piano.I can usually do a   15-100 cents pitch raise easily,in one = pass,with no adjustments.Give it a try,and on the C4 octave,just have them g= oing slow to the sharpe side,if it is a lot flatter. Best , Hazen Bannister</BLOCKQUOTE> </HTML>