<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2900.2802" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Here is a pictures of an assortment of = brass-mass - all done from round stock, bandsaw and small drill press.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2><IMG alt="" hspace=0 src="cid:003c01c628dc$bcf903b0$0201a8c0@DESKTOP" align=baseline border=0></FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Below is picture of them = installed.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><IMG alt="" hspace=0 = src="cid:003d01c628dc$bcf903b0$0201a8c0@DESKTOP" align=baseline border=0></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Terry Farrell</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>----- Original Message ----- </FONT> <DIV><FONT face=Arial size=2>> I'm finally getting around to = working on the piano which had a boomy <BR>> crossover from the long bridge to the = bass bridge.  I'm envisioning <BR>> getting some rolled brass stock = and cutting off pieces for <BR>> this.  I've cut aluminum with a = carbide blade, I think brass might be <BR>> a little harder.  How = difficult is this to do?  I'd drill a screw <BR>> hole in the center and = temporarily set under the bridge until I get <BR>> the impedance I want.<BR>> = <BR>> How do you pro's do this?  Where do you source your material and = what <BR>> is your favorite means of machining it?<BR>> <BR>> Andrew = Anderson</FONT></DIV></DIV></BODY></HTML>