<HTML><FONT FACE=arial,helvetica><BODY BGCOLOR="#ffffff"><FONT SIZE=2 FAMILY="SANSSERIF" FACE="Century Gothic" LANG="0">In a message dated 12/23/00 10:06:04 AM Eastern Standard Time, <BR>BUNKYPIANO@AOL.COM writes:
<BR>
<BR></FONT><FONT COLOR="#000000" SIZE=2 FAMILY="SANSSERIF" FACE="Arial" LANG="0">
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Exactly what does Baldwin
<BR>say the problem is? And there is a problem, believe me....If there was
<BR>adequate preparation at the factory they should cull these out, not put <BR>them
<BR>on the concert tour.......How about it Baldwin? Any answers? </BLOCKQUOTE>
<BR></FONT><FONT COLOR="#000000" SIZE=2 FAMILY="SANSSERIF" FACE="Century Gothic" LANG="0">
<BR>I have called the factory on this very problem. Their torque tolerlances are <BR>180 - 250 lbs. My wrench only goes to 200. I can't measure beyond that. I <BR>am sure, however, that some pins actually go past the 250 mark.
<BR>
<BR>Mike Bratcher</FONT></HTML>