<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2900.2668" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3> </FONT> <DIV><EM>Either the photos are out of sync with each other or my = eye is off, today. It looks to me that the knuckle is just a tad larger than = the original.</EM> </DIV> <DIV> </DIV> <DIV>Yes it is, but only a tiny bit and I'm not so sure its not just = that the new knuckle is round an not flattened.</DIV> <DIV> </DIV> <DIV><EM>AND, it looks like the flange center to knuckle molding = center is shorter on the new one. If that is the case then, the new shanks = won't work unless you move the knuckle out about 1mm - 1.5mm. That's = what it appears to me to be the case.</EM></DIV> <DIV><EM>Regards,</EM></DIV> <DIV><FONT face=Arial size=2><EM>Joe Garrett, = R.P.T.</EM></FONT></DIV><FONT face=Arial size=2><EM></EM></FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face=Arial size=2><EM></EM></FONT></FONT> </DIV> <DIV><FONT face=Arial size=2><FONT face=Arial size=2>Actually, = in this case, the knuckle is actually a little bit farther out (maybe a half-millimeter) = from the hammer rail than the original. The flange center to knuckle is the same, = but the flange screw hole to flange center is the half millimeter further apart = on the new part. That is an Abel shank/knuckle/flange. The Renner is the same way.</FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face=Arial = size=2></FONT></FONT> </DIV> <DIV><FONT face=Arial size=2><FONT face=Arial size=2>Terry = Farrell</DIV> <DIV><EM><BR></EM></DIV></FONT></FONT></BODY></HTML>