<DIV>Thanks, Jon.</DIV>
<DIV>&nbsp;</DIV>
<DIV><B><I>Jon Page &lt;jonpage@comcast.net&gt;</I></B> wrote:</DIV>
<BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">Back the screws off until the buttons drop off (into a short container).<BR><BR>This is a good opportunity to reinforce the hammer rail (especially if the<BR>wippens are off as well) with long sheet rock screws. If I haven't described<BR>this procedure on the list, I will do so with accompanying pix; it was part of<BR>a presentation for the RI Chapter last year. (jpg attached) End of tangent<BR><BR>To squarely install new buttons, use hammer removing pliers to hold the<BR>button against the rail. Reverse the plunger bolt so that the head is <BR>supporting<BR>the button. The prongs which straddled the shank now will straddle the <BR>eyescrew.<BR><BR>Use moderate pressure gripping the pliers and turn the screw in,. When the<BR>threads are in sufficiently the button will spin on the bolt head. That <BR>usually is<BR>enough. If you have further ambition to insure their tightness after all
 <BR>are installed,<BR>hold each button with your fingers and give the screw an eight to quarter <BR>turn.<BR><BR>Regards,<BR><BR>Jon Page</BLOCKQUOTE>