<HTML>In a message dated 7/23/01 2:58:30 PM Central Daylight Time, mfarrel2@tampabay.rr.com writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">I have blow distance set at a short 1-3/4" (I would certainly prefer to not make it any shorter - this dead-as-a-doornail piano needs all the hammer power it can get!), and everything regulates out real nice so that I end up with 3/8" dip with 0.025" aftertouch. I am solving the problem for now by raising the hammer rest rail just enough so that the shanks don't click against the metal piece, but that makes the hammers rest right on the rest rail - but it seems better than the clicking. Any ideas would be appreciated. Terry Farrell </BLOCKQUOTE> Terry I have had the same problem, and your solution seems to be the only one. Wim </HTML>