<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1479" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Dave Doremus asked: "<FONT = face="Times New Roman" size=3>Hi List, I am facing replacing all key leads in a S&S D, = due to major <BR>swelling/corrosion problems. Has anyone, especially those who do a = <BR>lot of re weighing, got a tool that will help cleanly remove so many = <BR>leads? I seem to remember a set of pliers advertised for this job but <BR>at the = time I balked at the price."</FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" size=3></FONT></FONT> </DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3><FONT face=Arial size=2>Dave,</FONT></FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3><FONT face=Arial size=2>I have such a tool. However it only works on key = leads w/hole all the way through the key(s). If I were to make another one, I'd make = the "anvil" on a pivot, which would cause less trauma to the key(s). I'll = post a picture of it after this.</FONT></FONT></FONT></DIV> <DIV><FONT face=Arial size=2><FONT face="Times New Roman" = size=3><FONT face=Arial size=2>Best Regards,</FONT></DIV> <DIV><BR>-- <BR>----Dave</FONT></FONT></DIV> <DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool Police<BR>Squares R I</FONT></DIV></BODY></HTML>