<HTML>Jack, Thanks for this bit of info.  I'll check it out next time I get a c= hance to work on a Brambach.  I couldn't see an adjustment screw anywhe= re.   Always something new(and old) to learn, and always someone willing to sh= are their experience! Thanks again, Dave Stahl In a message dated 8/4/04 8:51:49 AM Pacific Daylight Time, JWyatt1492@a= ol.com writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-= LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Hello David,    I suppose you could regulate the drop by bending the spoon.  But I would suggest you use the screw adjustment instead.    You will find the adjustment point at the top of the flange thru the window just behind the center pin.  If you will look straight down at the top of the flange you will see it. Regulate this action exactly like a  (regular) action.  While it looks different it works the same and just as well. BTW  there are three different   Brambachs. The 5'3' is  their best scale. Regards, Jack Wyatt </BLOCKQUOTE> </HTML>