<html>
Dale,<br>
<x-tab> </x-tab>Only in
the case of some screw that I was trying to correct.<br><br>
Greg<br><br>
At 02:38 AM 9/8/2002, you wrote:<br>
<blockquote type=cite class=cite cite><font face="Times New Roman, Times" size=2><i>In
a message dated 9/7/2002 7:09:15 PM Pacific Daylight Time,
gnewell@ameritech.net writes:<br><br>
</i></font><br>
<blockquote type=cite class=cite cite>Subj:<b>Re: pulley keys - special
tool from oliag (wood washers) </b><br>
Date:9/7/2002 7:09:15 PM Pacific Daylight Time<br>
From:<a href="mailto:gnewell@ameritech.net">gnewell@ameritech.net</a><br>
Reply-to:<a href="mailto:pianotech@ptg.org">pianotech@ptg.org</a><br>
To:<a href="mailto:pianotech@ptg.org">pianotech@ptg.org</a><br>
<i>Sent from the Internet </i><br><br>
<br>
Hi Greg<br>
But why would you want to move the pin for or aft unless you plan
on moving the balance rail. Otherwise the front of the key would bind or
have a huge gaposis at the key slip. Just my thought.<br>
Dale Erwin</blockquote><br><br>
<blockquote type=cite class=cite cite><br>
Newton,<br>
Again, I beg your
indulgence this once more. Does this system <br>
(Onesti's) put back the pin hole exactly where it was before or do you
have <br>
the option to, say, center it more in the key stick or even move or fore
or <br>
aft if so desired?<br><br>
Greg Newell</blockquote><br>
<font face="Times New Roman, Times" size=2><i></blockquote>
<x-sigsep><p></x-sigsep>
Greg Newell<br>
<a href="mailto:gnewell@ameritech.net" eudora="autourl">mailto:gnewell@ameritech.net</a></font></i></html>