<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1400" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>There's one (of many?) thing I've never = understood. Exactly where are the two diameter front rail punchings designed to be used?</FONT></DIV> <DIV><FONT face=Arial size=2></FONT><FONT face=Arial = size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>I'm finding that this action was poorly = built at the factory also. After leveling the white keys, I installed the black = keys, and found that several white keys were then too high. Finally figured out that those white keys, were also resting on the punching pile for = the adjacent sharp (sharp center rail pin is too close to the adjacent natural). Is the only easy/quick solution to this to trim the punchings? = Will they stay in place (not rotate)? <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Terry Farrell</FONT></DIV></FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>I'm getting in on this thread a bit = late. I'm wondering if the Toooner, who "rebuilt" that sucker, put 7/8" punchings = in, instead of the usual 3/4"?</FONT></DIV> <BLOCKQUOTE dir=ltr style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; = BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px"> <DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool Police<BR>Squares R I</FONT></DIV></BLOCKQUOTE></BODY></HTML>