<!doctype html public "-//w3c//dtd html 4.0 transitional//en"> <html> <body bgcolor="#FFFFFF"> Mike, If you take the action out, you will probably find that the hammer butts are the brass plate with screw type.  After you have all the center pins in correct position, tighten all the butt plate screws from the back.  I just did this a couple weeks ago.  Simple, and ends the walking pin situation. Regards, Clyde Mike Kurta wrote: <blockquote TYPE=CITE><style></style>     Hi All:    I keep running across older Yamaha consoles, mainly schools and churches that have hammer shank pins that have slid sideways.  Often they've moved so far as to cause hammer wobble and even inoperative hammers.  Because of cost limitations I've been able to pry most of these back into position and dab a bit of Titebond over the end of the flange to keep the pin in place.    I know these need repinning, but so far this has worked.  Aside from the metal pin retainers sold to limit pin movement, is there  a better way besides repinning I should consider?    Mike Kurta</blockquote> </body> </html>