<html>
<head>
<META HTTP-EQUIV="Content-Type" CONTENT="text/html; =
charset=us-ascii">
<meta name=Generator content="Microsoft Word 10 (filtered)">
<style>
<!--
/* Style Definitions */
p.MsoNormal, li.MsoNormal, div.MsoNormal
        {margin:0in;
        margin-bottom:.0001pt;
        font-size:12.0pt;
        font-family:"Times New Roman";}
a:link, span.MsoHyperlink
        {color:blue;
        text-decoration:underline;}
a:visited, span.MsoHyperlinkFollowed
        {color:purple;
        text-decoration:underline;}
span.EmailStyle17
        {font-family:Arial;
        color:navy;}
@page Section1
        {size:8.5in 11.0in;
        margin:1.0in 1.25in 1.0in 1.25in;}
div.Section1
        {page:Section1;}
-->
</style>
</head>
<body lang=EN-US link=blue vlink=purple>
<div class=Section1>
<p class=MsoNormal><font size=2 color=navy face=Arial><span =
style='font-size:
10.0pt;font-family:Arial;color:navy'> </span></font></p>
<p class=MsoNormal><font size=2 color=navy face=Arial><span =
style='font-size:
10.0pt;font-family:Arial;color:navy'> </span></font></p>
<p class=MsoNormal style='margin-left:.5in'><font size=2 =
face=Arial><span
style='font-size:10.0pt;font-family:Arial'><br>
<br>
I clean the screws with a wire wheel on a grinder. I put them in a box =
with
chicken wire. (the very small squares, which are about 1/2" =
square),. I
spray them with the same gold paint as the plate. Unless they are nickel =
plated
to begin with. You should polish those up, and spray them with a clear =
coat of
lacquer. <br>
<br>
I leave the hitch pins in, and spay them. That is not a problem. You can =
spray
the agraffes, too, but for a super look, take them out and polish then, =
since
they are brass. Keep should them in order when you take them out, and =
put them
back in the same hole. <br>
Wim </span></font></p>
<p class=MsoNormal><font size=2 color=navy face=Arial><span =
style='font-size:
10.0pt;font-family:Arial;color:navy'> =
</span></font></p>
<p class=MsoNormal><font size=2 color=navy face=Arial><span =
style='font-size:
10.0pt;font-family:Arial;color:navy'> =
Gerald-Wim,</span></font></p>
<p class=MsoNormal><font size=2 color=navy face=Arial><span =
style='font-size:
10.0pt;font-family:Arial;color:navy'> =
Someone
mentioned putting a spent firearm shell casing over each agraffes before
spraying.. I haven’t tried this yet and can’t remember the =
caliber
required. You could bring one to a gun shop or mic. the O.D. =
</span></font></p>
<p class=MsoNormal><font size=2 color=navy face=Arial><span =
style='font-size:
10.0pt;font-family:Arial;color:navy'> =
Tom
Driscoll</span></font></p>
</div>
</body>
</html>