<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1458" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial color=#0000ff size=2></FONT> </DIV> <BLOCKQUOTE dir=ltr style="MARGIN-RIGHT: 0px"> <DIV class=OutlookMessageHeader dir=ltr align=left><FONT = face=Tahoma size=2><BR></FONT> </DIV> <DIV><FONT face=Arial size=2>Terry,</FONT></DIV> <DIV><FONT face=Arial size=2>My preferred method is fairly old, = but has proven good. Epoxy and Heavy Duty Soldering Iron. It's time consuming, but = works well.</FONT></DIV> <DIV><FONT face=Arial size=2>Best Regards,</FONT></DIV> <DIV><FONT face=Arial><FONT size=2>Joe Garrett, R.P.T.<BR>Captain, = Tool Police<BR>Squares R I<BR><SPAN class=452260314-02102004><FONT color=#0000ff> </FONT></SPAN></FONT></FONT></DIV> <DIV><FONT face=Arial><FONT size=2><SPAN = class=452260314-02102004><FONT color=#0000ff>Epoxy can be warmed with a heat gun or blow = dryer, whatever, after you place it on the cracks.  It becomes very thin = and migrates into the cracks very well, but also sets quickly.  Use = some tape to build dams around the area, set the bridge pins where you want = them, apply glue then heat.</FONT> <FONT color=#0000ff> Allow 24 = hours to cure.</FONT></SPAN></FONT></FONT></DIV> <DIV><FONT face=Arial><FONT color=#0000ff size=2><SPAN class=452260314-02102004></SPAN></FONT></FONT> </DIV> <DIV><FONT face=Arial><FONT color=#0000ff size=2><SPAN class=452260314-02102004>Paul C</SPAN></FONT></FONT></DIV></BLOCKQUOTE></BODY></HTML>