<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2900.2722" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Problem found on newer K&C 600 = (Samick) needing routine regulation after break in period. </FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Found:</FONT></DIV> <DIV><FONT face=Arial size=2>Dip = 1/2"</FONT></DIV> <DIV><FONT face=Arial size=2>Blow = 2 1/8</FONT></DIV> <DIV><FONT face=Arial size=2>Let off = 1/8" +</FONT></DIV> <DIV><FONT face=Arial size=2>Looks like hammers are over = centering.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Trying to put decent distances into = play makes for strange hammer setting, way too much aftertouch and still the question = of possible overcentering hammers. Hammers shanks at rest now = look like they have a very shallow angle from horizontal,  Could it be = the stack is simply too low to start with? How does one check that or what do I = need to know before calling Samick? Is this where the magic line comes into play? Anybody have the key bed to hammer flange pin height = available? Any suggestions welcome!</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Thank you,</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Joseph Alkana = RPT</FONT></DIV></BODY></HTML>