<html> <head> <META HTTP-EQUIV="Content-Type" CONTENT="text/html; = charset=us-ascii"> <meta name=Generator content="Microsoft Word 10 (filtered)"> <style>  </style> </head> <body lang=EN-US link=blue vlink=purple> <div class=Section1> Tom, After viewing the = photos, I see where there is another problem. You have the Jig set up, so that the = key goes into the cutter Left of center, of the cutter. You are not getting = efficient use of the Planer in this way. You should be feeding Right of the center = of the Planer. Same principle as Routing. So, when you make the next one mount everything about 1" to 1 1/2" to the right. Either that or = just put a spacer on the fence for a test. Best Regards, Joe Garrett, RPT, = (Oregon)   Joe, =       Observant Lad aren't you!       I noticed the setup being off center after downloading the images but I = was too lazy to re-shoot.       I had just laid the table on the press with a junk key to demonstrate = the jig. In a "real" procedure the jig places the key in the center of = the planer.        As the table can be screwed to the drill press in any position, on the = next real setup I'll line the key up to the right of center and give it a = try. Thanks for the tip.       Tom Driscoll RPT       </div> </body> </html>