<!doctype html public "-//W3C//DTD W3 HTML//EN">
<html><head><style type="text/css"><!--
blockquote, dl, ul, ol, li { padding-top: 0 ; padding-bottom: 0 }
--></style><title>shank strike weights</title></head><body>
<div>><font face="Arial" size="-4" color="#000000">have to take a
closer look at knuckle radius a lot closer.</font></div>
<div><br></div>
<div>I'm not talking so much about knuckle radius/diameter as I
am</div>
<div>about having them pressed onto the shank to an consistent
height.</div>
<div><br></div>
<div>I had to remove a few, sand the core shorter and press them
back</div>
<div>on to a desired height. A caul for pressing does the trick. (jpg
attached)</div>
<div>This one didn't last long because the wood compressed on the
shank</div>
<div>and wasn't accurate through the job. I still need to get around
to making</div>
<div>one out of metal or HMD Plastic.</div>
<div><br></div>
<div>Also, I'd like to follow-up on a set and remeasure through
humidity cycles.</div>
<x-sigsep><pre>--
</pre></x-sigsep>
<div><br>
Regards,<br>
<br>
Jon Page</div>
</body>
</html>