<HTML><FONT FACE=arial,helvetica><FONT  SIZE=2>In a message dated 2/9/02 5:10:19 PM Central Standard Time, jaymercier@hotmail.com (Jay Mercier) writes:
<BR>
<BR>
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">After witnessing the first set of the Keith Jarrett trio, I thought it would 
<BR>be good to settle back to what's familiar - watching the technician polish 
<BR>up the unisons at intermission.
<BR>
<BR>What was supposed to be familiar, wasn't, - he was fine-tuning treble/high 
<BR>treble near the bridge with a tool I'm unfamiliar with, or at least I 
<BR>couldn't see it very well in the dim lighting.
<BR>
<BR>I'm sure most of you know what he was using and how he was tuning, but I 
<BR>don't. Could anyone fill me in?
<BR></BLOCKQUOTE></FONT><FONT  COLOR="#000000" SIZE=3 FAMILY="SANSSERIF" FACE="Arial" LANG="0">
<BR>The tool was probably the one known as a False Beat Eliminator or some other tool made and used for the same purpose such as a modified screwdriver or a brass rod.
<BR>
<BR>False beats can creep up during performance because heavy playing can drive the strings up the bridge pins. &nbsp;More likely however, he was using this tool to settle strings which were not staying in tune. &nbsp;During high level work as well as ordinary tuning, it is common to encounter strings which will go very flat on hard blows. &nbsp;Pull it back to pitch, hit it hard again and down it goes again and not just a little, 10-30 cents (way off, rapid beats) or more.
<BR>
<BR>I approach this problem in two ways using the False Beat Eliminator only as a last resort. &nbsp;When a string just won't settle, I pull it sharp by an amount that would ordinarily be way too much such as 10-30 cents. &nbsp;A hard, sharp blow brings it down instantly. &nbsp;Sometimes, further hard and sharp blows bring it once again way flat. &nbsp;I may try pulling sharp again, maybe a little more. &nbsp;When this just does not work, I pull the string a little sharp, then give a good and quick jab with the False Beat Eliminator. &nbsp;This will usually cause the string to go very flat, as much as 50 cents or more but when it is pulled up again, it will stay put.
<BR>
<BR>Sometimes, it takes more than one attempt. &nbsp;The important thing to consider when using such a tool is damage to both the string and the bridge. &nbsp;You can break a string or induce false beats into it by distorting the string with too much force. &nbsp;The bridge is made of wood, so too much force can crush the material.
<BR>
<BR></FONT><FONT  COLOR="#000000" SIZE=2 FAMILY="SANSSERIF" FACE="Arial" LANG="0">Bill Bremmer RPT
<BR>Madison, Wisconsin
<BR> <A HREF="http://www.billbremmer.com/">Click here: -=w w w . b i l l b r e m m e r . c o m =-</A> </FONT></HTML>