<html> Lance, It's not clear entirely clear from your post, but it sounds as though you are describing a single brass or steel wheel  such as Steinway #008760.   If this piano is being used on a stage, why wouldn't you use their double rubber caster #8734?  It's a Darnell  ballbearing caster with additional bearings around the wheel hub.  I'm not sure the Steinway style wheel comes in more than one hardness, but the Apsco (bless them) version does (less the hub bearings).  These wheels can, in fact, roll too easily, at times.   Good luck. David Skolnik skolnik@attglobal.net At 08:49 AM 10/12/2000 -0500, you wrote: >Dearest list, >I have two customers with new Steinway D's. The new ones have a wheel that >is even smaller (and rounded as opposed to flat) than the older ones. This >is putting deep marks on the stage. Both are hoping to get something like >the nice wide casters on Baldwins instead of the big dollies that most halls >use. I know I can put the little three wheel casters on it, but was >wondering if anyone knew if someone made something that would fit on the >Steinway as is. Thanks. > >Lance Lafargue, RPT >Mandeville, LA >New Orleans Chapter >lafargue@iamerica.net > </html>