<html>
<font size=3>At 10:22 AM 05/09/2001 -0400, you wrote:<br>
<blockquote type=cite cite>Misaligned pinblock hole:<br>
I just finished drilling out a pinblock (Bolduc) for a grand.
One<br>
hole (in the bass) ended up misaligned so that the edge of the hole<br>
is slightly under the plate (about 1/128th inch) on the agraffe
side.<br>
I see two options: 1) 2) file the bottom edge of<br>
the plate hole to prevent the pin contacting the plate. (The
holes<br>
were drilled at a 5 degree angle.) I will be using bushings.<br>
Any advice?<br>
Thanks,<br>
Larry Toto<br>
</blockquote><br>
plug and redrill<br>
</font></html>